How to reconstitute a peptide vial: water, concentration and syringe units
4 views2 min read
Freeze-dried peptides arrive as a powder. Here is how the water you add sets the concentration, and how to turn a dose into a draw on the syringe.
Table of Contents
Most peptides ship as a freeze-dried powder because it stays stable much longer than a liquid. Before use the powder is mixed with bacteriostatic water, which is called reconstitution. The maths is simple once you see it as one rule: concentration = amount in the vial divided by the water you add.
What you need
- The peptide vial and a vial of bacteriostatic water (our peptide vials ship without water).
- Sterile syringes: a larger one to add water, and a 1 mL insulin syringe for dosing.
- Alcohol swabs for the vial tops and your hands.
Step 1: choose how much water to add
The amount of water does not change how much peptide you have. It only changes how strong each millilitre is. A 5 mg vial mixed with 2 mL of water gives 2.5 mg (2,500 mcg) in every mL. The same vial with 1 mL gives 5,000 mcg per mL, so each dose takes half the volume.
| Vial | Water added | Concentration |
|---|---|---|
| 5 mg | 1 mL | 5,000 mcg per mL |
| 5 mg | 2 mL | 2,500 mcg per mL |
| 10 mg | 2 mL | 5,000 mcg per mL |
| 10 mg | 3 mL | 3,333 mcg per mL |
Step 2: mix gently
Wipe both tops with a swab. Draw the water, then let it run slowly down the inside wall of the vial rather than spraying onto the powder. Roll the vial between your fingers until it is clear. Do not shake it, because foam and rough handling can damage the peptide.
Step 3: turn a dose into a draw
Divide the dose by the concentration to get millilitres, then multiply by 100 to read it as units on a standard 100 unit insulin syringe. For example, a 250 mcg dose from a 2,500 mcg per mL solution is 0.1 mL, which is 10 units.
The calculator on each peptide product page does this for you and also shows how many doses the vial holds and how long it lasts at your chosen schedule.
Storing the mixed vial
Keep a reconstituted vial in the fridge and out of light, and follow the storage notes on the product page. Do not freeze it again. Discard it if it turns cloudy, changes colour or has particles.
Common mistakes
- Mixing up mg and mcg. 1 mg is 1,000 mcg.
- Reading millilitres as units. 0.1 mL is 10 units, not 1.
- Adding so little water that the dose is too small to measure accurately.
This guide is general information, not medical advice. It does not replace a doctor. Products labelled for laboratory research are not approved for human use.
